Wenzhou stainless steel ball valve,Wenzhou valve,Wenzhou valve manufacturer-Wenzhou Junkai Valve

Two reasons for the failure of the stainless steel ball valve seal! ! !

Time : 2023-05-04 Visited :  91 次

Wenzhou Longwan Junkai Valve is a professional manufacturer of stainless steel valves. The main products are: stainless steel ball valve, stainless steel Y-type filter, stainless steel flange, stainless steel mirror, stainless steel gate valve, stainless steel globe valve, stainless steel check valve, etc. The company has complete equipment, advanced technical quality, scientific management, complete testing means, and has established a perfect quality assurance system. Equipped with advanced physical and chemical analysis, mechanical properties, water pressure, air pressure, flaw detection and other testing equipment, each process from raw materials to finished products is inspected by special personnel, forming a complete inspection process.
The seal failure of the stainless steel ball valve during use may be caused by the damage of the stainless steel ball valve bearing, but it is not the only reason! There are other factors that can cause the seal failure of stainless steel ball valves. Let’s listen to Junkai Valve’s introduction.
1. Natural failure
Some stainless steel ball valve seals are always in the medium, and the seal failure of the ball valve will occur when the service life of the sealing element is exhausted.
2. The pressure fluctuation at the pump inlet is large
If the inlet pressure of the stainless steel ball valve pump is too small, the pressure in the cavity will suddenly decrease, and the liquid in the sealing cavity will flow back into the pump cavity, causing the sealing surface to dry and rub against, which will generate huge heat in a short time and cannot be taken away, resulting in burning of the sealing surface. Then the sealing surface of the ball valve will fail; and when the pump inlet pressure is too large, the sealing pressure will rise and exceed the tolerance range, which will cause the sealing failure of the stainless steel ball valve.